Alloy 50НХС
Our consultant will save your time!
Alexey
sales department
+38 (093) 727-19-11
The precision material of grade 50HXS is of the type of magnetically soft materials, which means it can perfectly magnetize to full saturation even under the action of a low-strength magnetic field. This feature determines the main scope of application of such raw materials.
Application
Basically, an alloy with a similar name is used in the production of transformer-type cores and various communication instruments operating at a high frequency. Also, such materials are actively used in many other areas of the industrial complex, such as electrical engineering and telemechanics, the production of various computer technology or measuring equipment. Due to the high magnetic permeability, rather low coercive force and some other specific features without such raw materials, power engineering and the production of magnetic wires intended for working in contact with corrosive media (such as sea water) are not enough.
The fabrication of such a material as the 50HXC alloy requires the use of a special complex of metallurgical furnace equipment, constant control over strict compliance with the technology and accurately verified the qualitative and quantitative composition of the charge. The result of this time-consuming and complex procedure is the receipt of high-quality technological raw materials with a certain set of physical and mechanical characteristics and complete absence of harmful impurities.
Properties
| Chemical composition as a percentage | ||||||||
| silicon | carbon | iron | manganese | phosphorus | sulfur | nickel | copper | chromium |
| 1.1−1.4 | Up to 0,03 | 42.03−45 | 0.6−1.1 | Up to 0.02 | Up to 0.02 | 49.5−51 | Up to 0,2 | 3.8−4.2 |
| Mechanical properties (at 20 ° C) | ||
| Name of the characteristic | The numerical value for tape products according to GOST 10160−75 | |
| tape | Cold-worked tape | |
| Short-term tensile strength, MPa (ss) | 440 | 780 |
| Yield point, MPa (sT) | 145 | 685 |
| Relative elongation at break,% (d5) | 35 | 3 |
| Relative narrowing,% (y) | 60 | 15 |
Features of welding
| The alloy has limitations on weldability | The welding process requires some preliminary preparation (warming the contacting surfaces to one hundred and one hundred and twenty degrees and subsequent heat treatment of the seam zone) |
| The alloy has no weld constraints | No additional operations are required |
| Hard to weld material | It is necessary to warm the contacting surfaces to two hundred or three hundred degrees, the subsequent annealing and heat treatment after the end of joining the elements of the structure by a welded process |
Buy at the best price
On our site there is a very wide range of products from the alloy 50HXS, as well as other precision materials. Experienced staff will help you choose the most convenient way to deliver the goods. High quality of materials of this type and full compliance of products with the requirements of regulatory documentation for it, as well as maximum comfort when working with the client is the company’s constant credo for many years of its existence.